-
Home made puller. 4 inch plastic pipe from Home Depot with notch cut to clear wires.
All thread shaft with 6 by 1.0 mm bolt welded on the tip.
Could have used a 1/4 inch all thread shaft if I had one, and run a 6 by 1.0 mm die on the end.
Anything with a hole to put shaft through. I used a milling hold down clamp.
Ratchet wrench for quicker work.
Much better than using a slide hammer as a puller.
Last edited by C. Dolan; 02-08-2017 at 11:27 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules