This one a flange to sleeve clamp I made:
THis one a sleeve adapter I made:
This one a flange to sleeve clamp I made:
THis one a sleeve adapter I made:
really? I was told 7-9 by HmF! Hmm, I'm going to fit the hotbodies MFP growler and see how it runs compared to the hmf and ecm 44T HMF ECM. if it runs terrible I'm switching the ecm to the tunable ecm and get the power back to "normal". The HB can weighs just over 2lbs.
My HMF can that was cut 4" weighs 5.15 lbs
the hot bodies MGP carbon can weighs 1.75
ordered the can and will retro fit and then dyno tune it.
This is with the rear wheel and rotor mod should take another 10.5-11lbs and then I'm going after the engine bolts
Apex isn't too far from me. I didn't know they did Dyno tuning...