FYI .. here's whats in the clutch kit ...
FYI .. here's whats in the clutch kit ...
If you email Adam he will send you the instructions. That's what I did pre purchase. It looks fairly simple. Info@ebr.com
Basically remove clutch line from cover. Remove cover and replace actuator. Remove 6 clutch springs and replace with new springs. Button back up and bleed clutch.
Is it possible to have EBR 1190 diagnosis of a motorcycle in the event of faults without an authorized EBR-dealer and specialized programs?
In Russia only one dealer and he is in Moscow. I live in St. Petersburg - is more than 650 kilometers. I'm not going to visit it.
Am I able to independently install aftermarket exhaust and a new ECU without dealer? Is it possible to do simple operations, such as resetting the throttle or reading errors?
Is there some service manual for EBR? Does Eric sells software from this motorcycle?
Now I have Aprilia DD1200 and KTM 990 Super Duke. I only plan to replace both at EBR 1190.
Without Aprilia dealer it would be very difficult, although the dealer is stupid and incompetent. Situation with KTM is better than situation with Aprilia, but to change the injection map will still need a dealer ...
Last edited by zviadi; 02-19-2015 at 02:35 AM.
EBR 1190 RX
The EBR Exhaust kit with the ECM is a self install and includes the directions .. there is no need to visit a dealer.
I would like something like this:
http://www.erikbuellracing.com/store...cable-kit.html
Too bad that such software is not at EBR1190...
EBR 1190 RX
What would you do with it? Full diagnostics are built into the Dash .. you can monitor everything from coolant temp, to TPS%, fan voltage, to AFR ratio right on the screen. You cannot program the ECM however - but not sure if you would want to.
The only complaint I have to EBR is you cannot monitor the ECM inputs and readings while bike is moving .. it automatically goes back to speedo display.
With soft it would be possible to change fuel maps...
Can be reset throttle valve without a dealer? EBR have "ride-by-wire" or not?
EBR 1190 RX