Anyone have them? Is there enough power to run them? Any pics would be great
Anyone have them? Is there enough power to run them? Any pics would be great
Just a question about lights, has anybody rewired to allow low and high beams on at the same time??? I can kind of hold the switch in the middle and have both on but not very good.
You can add driving lights but need to watch the wattage. I would say you can ran a pair of 15-20 watt, not 35-50's.
EBR said it numerous times that you shouldn't run high and low at the same time. The heat sink can not support both lights being on and would burn up..
Last edited by TerryS1980; 11-12-2017 at 11:49 AM.
I’ll keep you posted. Got some piaa led driving lights
So, heated gear is a no-go? I have always worried about the capacity.
If you pull apart the left switch housing, you can grind a little detent in the middle of the switch cam and that will give you and middle button position to run both on at the same time.
"Love is the never ending act of forgiveness" -Peter Ustinov
2017 EBR 1190SX
2000 Buell M2
1995 Buell S2 (x2)
The headlight module has 2 heatsinks for the LED headlights. I assumed that one was for each bulb so running both would be ok.
But if Terry is right..."EBR said it numerous times that you shouldn't run high and low at the same time. The heat sink can not support both lights being on and would burn up.."
I dont want to risk,frying the the heat sink ,????????????????????????????? I will use low or high but not both until its been proven safe.
With the very minimal extra wattage available, and the whole headlight housing being a 'replacement only' deal, I don't think I'd risk it either. YMMV.