When you run 9000 km noticed that the clutch basket makes unusual noise. When you press clutch lever the noise is disappears.
At first I thought, that the case of worn clutch disc. I changed discs on Barnett, but the noise has not disappeared. Moreover - he began to progress.
Who basket rumbles louder than Ducati. This rumble is heard even on the move.
Does anyone have a similar?
Last edited by zviadi; 11-02-2015 at 02:56 AM.
EBR 1190 RX
I've been told the noise is common with a slipper clutch.
Mine no slipper clutch, full of stock.
EBR 1190 RX
On my KTM 990SD had the same thing, I replaced the clutch needle bearing. This bearing is not in clutch design of EBR, will have to change basket assembly.
Probably sunk spring torsional vibration damper. At the same time, too will have to change basket assembly.
The third reason - the play of the primary shaft of the gearbox.
EBR 1190 RX
The 1190RX comes with a slipper clutch stock.
Judging from the looks of your clutch basket you posted a few weeks ago I would think it is probably the springs in there wearing more and more causing the rumble noise. Mine has a rumble, but only when in neutral. EBR getting ready to start operations again soon, so it won't be long before a new basket is available.
At this bike in stock not slipper clutch. There is a pathetic imitation slipper, similar Aprilia Rotax (PPC - pneumatic power clutch).Originally Posted by oldtimerookie
On my Aprilia this PPC don't work, and all of my friends have the same situation on their Aprilias - if you need to gear down, we have to add gas.
Similarly.
Russian dealer sent a request to Eric and put a picture of my basket. Perhaps it replaced under warranty...
Basket costs nearly 1,100 euros
Last edited by zviadi; 11-02-2015 at 03:25 PM.
EBR 1190 RX
Nope.
Yep...
Has a slipper clutch , just not very slippery . Often change back two gears and dump the clutch without pulling big revs. If you change back low in the revs the rear wheel hops or skids because it doesnt slip.
Posting Permissions
Reply With Quote