Bike won't start

[Plotter]

I can hear it trying, but no actual ignition... I installed a PC5 last night, but it started up just fine... This afternoon it won't start... I put it on the jumper, but it's not the battery... Any help?

[Mike]

Maybe a bit of work, but disconnect the PC5...see if it'll start...
See, ya shoulda bought the other ECM..!

Mike

[Plotter]

I'm putting on the trickle charger for now, and will try again this evening... It said it was at 10%... I guess the PC5 is draining the battery...

[d_adams]

Check the status lights on the PC-V. If both are dimly lit, it's a power issue with the PC-V. If that's the case, it needs a jumper wire from pin 9 on the ecm, black plug and run it to the red wire on the PC-V. Don't ask me why, but I've seen a few with this problem.
One way to test that theory quickly is to have a laptop there, plug in the PC-V to the laptop so it gets power. Bike will most likely start right up.

[Plotter]

Check the status lights on the PC-V. If both are dimly lit, it's a power issue with the PC-V. If that's the case, it needs a jumper wire from pin 9 on the ecm, black plug and run it to the red wire on the PC-V. Don't ask me why, but I've seen a few with this problem.
One way to test that theory quickly is to have a laptop there, plug in the PC-V to the laptop so it gets power. Bike will most likely start right up.

Is something that develops? When I got it all hooked up, I started the bike up with the laptop connected to verify everything looked good.

[d_adams]

And with the laptop not connected, the bike doesn't start, correct?

[Plotter]

problem resolved... Dean Adams is the man!