In 1190 installed radial Nissin.
From some japanese motorcycles fit the front brake lever and clutch lever?
In 1190 installed radial Nissin.
From some japanese motorcycles fit the front brake lever and clutch lever?
EBR 1190 RX
I had read somewhere that zx14 uses the same lever.
I am using ASV ZX14 levers on my EBR .. they fit fine .. make sure you replace the plunger which is included in the ASV kit .. if you use the factory one it could lock up the front brake. I first bought a Chinese Knockoff set .. and they didn't fit as nice as the ASV lever for some reason. Probably because ASV included replacement hardware and the Chinese ones did not.
Last edited by dmhines; 06-18-2015 at 04:49 PM.
Any new info on getting replacement levers? I can't locate the expensive ASV levers and a check on one of theZX14 Imported CRG/Pazzo types don't fit.
Thanks guys
What year ZX? I looked at some nice looking, folding imported levers and they don't work.
Since you guys are messing with your controls and all, I wasn't able to tell for sure, but, is the left hand grip glued onto the bar or is that side an assembly slid over the bars like the throttle side?