1190 RX denoid......

[zviadi]

Dean Adams also viewed the construction of the solenoid:

http://ebrforum.com/showthread.php?1...full=1#post961

Photos of solenoid cable and the throttle body I have copied this post.
Interesting his opinion about the correctness of my actions for denoid.

[Carbonbolt]

@ zviadi, im using the OEM plug since the first km, for you it isn´t nessesary to order in the US.
In Germany it is on stock: http://shop.buell-parts.com/OEM-Widerstandsstecker-Solenoid-fuer-alle-Buell-1125er-Modelle

I have removed the solenoid completely and saved nearly 1,2kg.

[Mike]

Post #28 -
Just below picture center and slightly to the right.
The tab that's bent to the right overlapping another small tab.
As I recall (been a while on my 1125CR), leaving those two parts loose may provide an unexpected throttle flutter sequence when opened hard at higher rpm's.
Sitting still in the garage...you won't notice anything wrong. They move together just fine in that case.

That's...what is tied together.

Mike

[zviadi]

@ zviadi, im using the OEM plug since the first km, for you it isn´t nessesary to order in the US.
In Germany it is on stock: http://shop.buell-parts.com/OEM-Widerstandsstecker-Solenoid-fuer-alle-Buell-1125er-Modelle

I have removed the solenoid completely and saved nearly 1,2kg.

Thanx for info!
But they don't send in Russia. It is necessary to write them a letter...

[Carbonbolt]

Thanx for info!
But they don't send in Russia. It is necessary to write them a letter...

I will tell them that there will come an order from Russia. I call them this week.
Try it by email.
By the way: i dont earn money from them, we meet often on the track.

[zviadi]

Big thanx, Christian!
I wrote a letter yesterday morning, until there is no answer ...

[Carbonbolt]

Big thanx, Christian!
I wrote a letter yesterday morning, until there is no answer ...

...awnser will come. We called yesterday evening.

[zviadi]

Norbert wrote me reply. Thank you again for your help.

[bthibodeaux]

If you still have a problem getting the plug, I just ordered 3 of them, and will sell 2 of them at my cost plus postage. Thanks.

[Plotter]

I removed the solenoid and zip tied the connection with the new resistor... I pulled the cable and everything out... Man that thing was heavy...

Please confirm that the connector that you place the resistor in is what you are supposed to zip tie... Nothing to do with the linkage cable?...