Aftermarket parts lists

[MakingPAIN]

Things to add to the list:

• CRG - RC2 Brake and Clutch levers for 2008 Kawasaki ZX14
• Techspec - Tank Pads
• Liquid Performance eBay page - LAP's online discount part sales
• Öhlins - BU-888 is the 1125/RS rear shock, a drop-in part to the 1190RX/SX, a note though: these were all built in 2011 or earlier. If you purchase one, you'll have to have it serviced/rebuilt before you fit it to your bike or the seals will fail very quickly.
• Woodcraft - replacement/upgraded clip ons, replacement solid foot pegs, hand guards
• Shorai - Makers of the battery, battery cable, battery charger
• McMaster-Carr for Washers and O-Rings
• M18 Oil Drain Plug LH Washer - Equivalent to EBCF0092.1B6 - https://www.mcmaster.com/#97725a860/=1bnm6de
• M12 Oil Drain Plug RH Washer - Equivalent to EBCF0091.1B6 - https://www.mcmaster.com/#97725a250/=1bnm6vb
• Oil Filter Cover O-Ring - Equivalent to EBCF0003.1B6 - https://www.mcmaster.com/#9452k147/=1bnm7hx

Good looking out buddy. I updated the post.

[Cooter]

I got the ZX-14 brake lever for the SX master and it needed the plunger pin hole deepened so it didn't depress the piston too far (aka old Buell issues) and the stop light switch pin was in the total wrong spot, drilled and tapped a 1/4"-20 shouldered bolt for a switch stop to make it work, but in my opinion, not at all a drop in replacement.

[gdisaac07]

I got the ZX-14 brake lever for the SX master and it needed the plunger pin hole deepened so it didn't depress the piston too far (aka old Buell issues) and the stop light switch pin was in the total wrong spot, drilled and tapped a 1/4"-20 shouldered bolt for a switch stop to make it work, but in my opinion, not at all a drop in replacement.

You're correct. I also tried installing the ZX14 brake lever today and it did not work. Sorry for the bad info guys! Clutch lever works though.

[Cooter]

It's closer than nothing if you've got the skills to change it.

My set-up is all on an '08 STT anyway. Modded ZX-14 aftermarket lever on an EBR radial 19mm master, Ducati Monster smoked reservoir, stock line and ZTL2 caliper. So for me, $29 and the mods were worth not spending $189 for ONE EBR lever... Yikes. What a kick ass upgrade to the XB!

[Kid Thunder]

I ran the CRG ZX14 brake lever & it works fine. 7000 miles. The lever kit comes with different pieces for different bikes for the brake light. I think the one I used was fo a 600 Kawi. It's in the instructions. If not just give them a call & they will tell you.

[gdisaac07]

I got the correct CRG RC2 lever. It is the one for the 2005 Kawasaki ZX-6R (Part # 2RN-511-T-B). I have installed it and confirmed that it's working as OEM.

@MakingPAIN, can you update the master list so that it reflects it?

[gdisaac07]

This is a refactor of the OP. I'll update it as time goes on to be totally updated and help @MakingPAIN out.

The following is a constantly updated list of aftermarket parts vendors. If you have any more suggestions, please add a post with a manufacturer, part number, and link! The vendors are in alphabetical order per category, and some vendors are in more than one category.

OEM Parts Supply

EBR Parts Supply - http://www.erikbuellracing.net/store/

• Updated chain slider (Part # G0012.1B7A)

LAP eBay page, Liquid Performance - https://www.ebay.com/sch/liquid_performance/

Aftermarket Dealers

AF1 (Our Forum Sponsor) - https://www.af1racingaustin.com/
NCCR (Official European EBR parts supplier, plus other aftermarket parts) - http://ebutik.nccr.se/ebr-erik-buell-racing-1/
St. Paul Harley Davidson - https://sphdonline.com/

Bodywork

Bestem USA

• Carbon fiber replacement parts - http://www.bestemusa.com/1190-RX-SX_c_1930.html

Hotbodies Racing

• Full race fiberglass bodywork - https://www.hotbodiesracing.com/prod...race-bodywork/

PowerBronze

• Seat cowl and tire hugger, 1190RX - http://www.powerbronze.co.uk/searche...RX&yeartext=15
• Seat cowl and tire hugger, 1190SX - http://www.powerbronze.co.uk/searche...SX&yeartext=15

Screensforbikes.com

• 1190RX windscreen, short and tall - https://www.screensforbikes.com/shop...rb-1190-rx-14/

Slingshot Racing

• Keyless Billet Gas Cap - https://www.slingshotracing.net/cata...cap-p-868.html

Twisted Designs

• Tail Tidy Kit (Currently Out of Stock) - https://www.ebay.com/sch/twisteddesi...1&_ipg=&_from=

Seat

Stitch Wilson

• Custom seats - http://customcycleseats.com/seats/custom-ebr-seats/

Rider Interface

ABM

• Clutch Lever (Part # KH43) - https://ab-m.de/en/motorcycle-access...lever-syntoevo
• Brake Lever (Part # BH21) - https://ab-m.de/en/motorcycle-access...lever-syntoevo

ASV

• Clutch Lever (Part # CRC511 or CRF311) - https://asvinventions.com/dmsearch?q=CRC511+CRF311
• Brake Lever (Part # BRC511 or BRF311) - https://asvinventions.com/dmsearch?q=BRC511+BRF311

CRG

• Clutch Lever (RC2 for 2008 Kawasaki ZX-14, Part # 2RN-611-T-B, Shorty and other colors available too) - https://www.revzilla.com/motorcycle/...4r-concours-14
• Brake Lever (RC2 for 2005 Kawasaki ZX-6R, Part # 2RN-511-T-B, Shorty and other colors available too) - https://www.revzilla.com/motorcycle/...suzuki-triumph

Knight Design

• 1" drop foot pegs, black, Sidetrax tread for Buell Black Lightning (Part #101410-1110) - http://www.knightdesignllc.com/index.htm

Motion Pro

• Adjustable throttle (Rev 2.1 Throttle tube, Part # 01-2778) - https://www.motionpro.com/c/rev2-throttle?v=10904

Vortex Racing

• Pegs -

Woodcraft

• Clip ons/bars (Part # 12-01 54mm) - https://www.woodcraft-cfm.com/cgi-bi...tion&key=12-01
• Solid foot pegs (Part # 04-BH1030Z) - https://www.woodcraft-cfm.com/cgi-bi...on&key=06-0300
• Hand guards (Part # 15-010) - https://www.woodcraft-cfm.com/cgi-bi...ion&key=15-010
• Bar end sliders (Part # 16-9299B) - https://www.woodcraft-cfm.com/cgi-bi...n&key=16-9299B

Protection

GB Racing

• Engine Case Protection - http://www.gbracing.eu/EBR.347/1190R...rotection.349/

R&G

• Frame sliders, cooler grills, assorted tidbits - https://www.rg-racing.com/browseBike/EBR/

T-Rex

• Frame sliders, engine sliders, axle slider - https://www.t-rex-racing.com/catalog...014%20-%202016

Techspec

• Tank Pads (Part # 62-0020-SS) - http://techspec-usa.com/motorcycles/...grip-pads.html

Exhaust

APH

• Exhaust - http://www.aph-performance-engineeri..._exhausts.html

Dean Adams

• Round can, oval can, or exhaust tips, including or excluding ECU (either the one with the map exclusively for the type you buy, or a tunable ECU) - http://ecommerce.deanadamsdesigns.co...x.php?cPath=22
• Various other tools - http://ecommerce.deanadamsdesigns.co...x.php?cPath=27

HMF

• Exhaust - https://www.hmfracing.com/exhausts/buell/rx-1190

Continued:

[gdisaac07]

Engine

Barnett

• Clutch plates and springs (Part # 303-30-20125), required if you're using a new exhaust and putting down more power than stock) - http://www.barnettclutches.com/1368/...ell-1125r.html

L.A. Sleeve

• Upgraded cylinder sleeves - https://www.lasleeve.com/

NGK

• Spark Plug (Part # CR9EKB) - https://www.amazon.com/NGK-CR9EKB-St.../dp/B001RLS29W

Electronics

BUELLTooth

• Quickshifter, regular shift or GP shift pattern - https://www.buelltooth.com/quickshifters.html

IDS

• Original designer of the ECU, sells ECU's with other tunes, plus a user-tunable one - http://idspd.com/xcart/products-ebr

Shorai

• OEM Lithium Battery (Part # LFX21A7-BS17, you must call Shorai directly to purchase one) - https://www.shoraidirect.com/en/c41-batteries
• Battery Charger (Part # SHO-BMS01) - https://www.shoraidirect.com/en/p216...-jp-power-cord
• Battery Cable - https://www.shoraidirect.com/en/p140...-cable-set-12v

Woodcraft

• Ignition bypass (Part # 43-0810) - https://www.woodcraft-cfm.com/cgi-bi...on&key=43-0810

Sprockets

JT Sprocket

• Steel, 43 tooth, Part # JTR1490.43 - https://www.amazon.com/JT-Sprockets-...001AVS70I?th=1
• Steel, 44 tooth, Part # JTR1490.44 - https://www.amazon.com/JT-Sprockets-...000GTYHVS?th=1

Supersprox

• Steel/Aluminum engineered sprockets - https://www.supersproxusa.com/products.php?cat=1125906

Vortex Racing

• Aluminum, 43 tooth, Part # Vortex-821-43 - https://www.amazon.com/Vortex-823-43.../dp/B003170ASQ
• Aluminum, 44 tooth, Part # Vortex-821-44 - http://store.58cycle.com/2Vortex_PN_...n%20821-44.htm

Suspension

Öhlins

• Front Fork Cartridge Kit (Call Seacoast Sport Cycle for NIX30 kit, installed for $1,750 + Shipping) - http://seacoastsport.com/
• Rear Shock (Part # BU-888 is the 1125/RS rear shock, a drop-in part to the 1190RX/SX. A note though: these were all built in 2011 or earlier. If you purchase one, you'll have to have it serviced/rebuilt before you fit it to your bike or the seals may fail very quickly) - https://www.ebay.com/itm/Ohlins-TTX3...y/202230827159
• Steering Damper (Part # SD000, requires bushing kit Part # A14010200UX0631) - https://www.amazon.com/Ohlins-SD-000.../dp/B0067F630I

Showa

• Stock Big Piston Forks and Shock -
• Race Shock - https://www.amazon.com/Buell-Erik-Ra...dp/B077DNQHLD/

Wilbers

• Race Shock - http://ebutik.nccr.se/ebr-erik-buell...ine-632-mono-c

Brakes

Diesel Moto

• Front Rotor -

EBC

• Brake Pads -

SBS

• Dual Sinter Front Brake Pads (Part # 856DS) -

Wave Rotor

• Front Rotor, Part # BL02FID

Fluids and Filters

YOU MUST USE 10W-40 SYNTHETIC ENGINE OIL IF YOU PLAN ON RIDING AT ANY TIME WHEN IT IS LESS THAN 40 DEGREES FAHRENHEIT. OTHERWISE, USE 20W-50 SYNTHETIC.

AMSOIL (EBR recommends that you use AMSOIL)

• 10W-40 Oil (Part # MCF+QT-EA) -
• 20W-50 Oil (Part # MCVQT-EA) -

HIFLO

• Oil Filter (Part # ) -

K&N

• Oil Filter (Part # KN-564) -

K&P Engineering

• Metal mesh oil filter (Part # ) - http://kandpengineering.com/product-catalog/s27/

McMaster-Carr

• M18 Oil Drain Plug LH Washer - Equivalent to EBCF0092.1B6 - https://www.mcmaster.com/#97725a860/=1bnm6de
• M12 Oil Drain Plug RH Washer - Equivalent to EBCF0091.1B6 - https://www.mcmaster.com/#97725a250/=1bnm6vb
• Oil Filter Cover O-Ring - Equivalent to EBCF0003.1B6 - https://www.mcmaster.com/#9452k147/=1bnm7hx

Mobil 1

• 10W-40 Oil -
• 20W-50 Oil -

Royal Purple

• 10W-40 Oil -
• 20W-50 Oil -

Spools/Stands/Restraints

Driven Racing

• Spools -

Pit Bull

• Spools (6mm, Delrin only) -
• Rear pit stand (Wide stand) -
• Front pit headlift stand (Pin #1) -
• Trailer Restraint System (Part # ) -

I will try to keep the list up to date. Please help out with it if you can. If there are any links that are broken, please let me know and try to provide a new, working link. Thank you!