Yes, but it's at almost 12000 rpm in that section of the table. 91 octane fuel is the lowest you'd want to run in this bike, I try to find 93 whenever I can. Most stations around me have it.
Yes, but it's at almost 12000 rpm in that section of the table. 91 octane fuel is the lowest you'd want to run in this bike, I try to find 93 whenever I can. Most stations around me have it.
Yeah there are pumps with 95 and 100vp race fuel here in phoenix. I run 95 as much as possible
For 300 bucks for a ecm with a tune and great vendor support from IDS. Why bother with anything else. 13.4.1 compression on pump 91 is tricky enough. For a bolt on map I am super happy with my IDS race tune.
Muleman... what tune did you get ids?? And your comparison to stock?? Like fueling issues at cruise speeds and smoothness throughout the tune
I run this tune (although it's on a programmable ecm, not this specific one) http://idspd.com/xcart/ebr-1190rx-sx...s-exhaust.html
with this
I run Deans tune also on this bike with a APH can.Thanks for the great tune Dean, http://idspd.com/xcart/ebr-1190rx-sx...s-exhaust.html
Attachment 1460
Last edited by EBRRider; 05-22-2017 at 04:45 PM.
EBRrider... I know when I got this bike I was talking to You about not upgrading it but now I have to make it louder. When your girls 300 is louder than your bike its time.. I see your aph has the stock trim bolted on. You make those tabs and weld them on for mounting or did aph do that.. looks trick...
Mr adams.. this could be a very novice question but does the ecm on these Bikes adjust tune for altitude and ambient temp? Because the more I read these computers are very stable and don't adjust much. So here it is I guess if your tune was made at sea level, and say me takes that tune and runs it at 1200 feet all the way up to 8500 feet like up north would I see fueling issues or the ecm will move the calibration to the new parameters.
Came that way.It is Louder than any 300 , Bam! Attachment 1461
I like it what does that set up run i know the ecm is 300 from Dean A.... does he make a sx version with tabs for body work??????