EBR purchase this sprocket for $194 excluding shipping.
On 1125 or XB there is a similar product G0600.07AH for $17.
Does anyone know - is identical parts?
EBR purchase this sprocket for $194 excluding shipping.
On 1125 or XB there is a similar product G0600.07AH for $17.
Does anyone know - is identical parts?
Last edited by zviadi; 02-01-2017 at 03:05 AM.
EBR 1190 RX
Simple part to have made with similar materials on a lathe in your homeland, and far less expensive.
The answer is - it's different parts))) In the case of 1125 - it's a sprocket, in the case of 1190 - it's a roller.
Agree.
But I'm afraid that idler sprocket have bearing inside... I did not remove - just looked at the outside of replacement chain and sprockets. It has damage on working surface.
Last edited by zviadi; 02-02-2017 at 12:52 AM.
EBR 1190 RX
Really wonder if we can do away with the idler ?
Without idler the upper part of the chain will lay down on swingarm and grind it.
I also need to change chain slider... at least it cost $38...
In this bike very quickly ends consumables parts.
EBR 1190 RX
The idler is probably built very similar to the one used on Buell's XB belt drive bikes. If so, the bearings are standard commercial sealed ball bearings which are easy to find. They are held in place by a snap ring on each side, and can be easily replaced. Here is a link showing how to replace the bearings on an XB idler: http://www.twinmotorcycles.com/artik...?cid=7&aid=292
Hopefully this information will be helpful if you decide to have a new idler fabricated locally.
Thanks.
In my opinion, idler roller is not so wide, as XB belt tensioner. It is exactly the width of 520 chain.
I can verify this in April. Now we have a winter off-season.
EBR 1190 RX
As buell-fan said...make your own.
You'll just have to pick your own bearing.
Measure a stock idler. Measure the od of the bearing, measure the id and width of the bearing. I'll guarantee you it's an off the shelf bearing.
Buy a new bearing. Have a shop manufacture the "wheel" to fit the bearing and be close to the original outer dimensions of the stock wheel.
Mike
Yesterday they removed idler sprocked.
Who can tell me the following information: on the new idler sprocket the metal part protrudes over the rubber sides or not? Has anybody pics of the new idler sprocket?
EBR 1190 RX
The bearing should have a number printed on it. It is the dimensions. That will let you source one easily through an industrial supply.