I plan on installing mirrors with integrated turn signals and remove the stock turn signals. Does anyone make a block off piece to fill in the holes left by the original turn signals?
I plan on installing mirrors with integrated turn signals and remove the stock turn signals. Does anyone make a block off piece to fill in the holes left by the original turn signals?
Unfortunately...there's actually a "raised" portion of the body panel, above the normal panel surface.
So any "cover" will have to be well above the surface...or take a grinder/sand paper to remove the lump, which will likely create a new hole.
Mike
Argh... I'll either order a race panel (just the side panels if they'll bolt up to the stock upper and lower) or modify the mounts into a GoPro mount or something.
Thanks for letting me know.
If you see what I did here when I put smaller turns on my RX, you could easily do the same and just put a black bolt in it. I used 1/8" sheet rubber and traced the shape of the stock base.
Until the 1190RS mirrors come in, I swapped in the shorter turn signals from the stock license plate bracket. It's not a tremendous difference, but it was quick and free for the moment.
Posting Permissions
Reply With Quote