Can someone post some pics of the wire harness routing in the tail?

I'm putting the bike back together, and am having trouble getting the wire harness just right. From the factory, I had a lot more room for the battery to go in, and I think I'm close but not exactly right just yet. Here's what I have:
http://i4.photobucket.com/albums/y10...psnmztlgkk.jpg
http://i4.photobucket.com/albums/y10...psed9vej0c.jpg
http://i4.photobucket.com/albums/y10...psrhoezv5m.jpg
http://i4.photobucket.com/albums/y10...pshsauxzcp.jpg
http://i4.photobucket.com/albums/y10...psq3viglrg.jpg

I know I don't have the ECM bolted down yet. Even before putting in the battery, I couldn't get the bolt towards the front of the bike to tighten. Something is just slightly off. Hoping to finish her up today.

Pull the battery up temporarily out of its position enough to allow fitting the ECM down all the way to put the front bolt in, then the rear bolt. Make sure the battery goes back all the way down into its slot.

Is there anything special about that front bolt? With the battery out, I've tried putting the ECM bolts in and it's been fighting me. The rear bolt goes in fine, but the front bolt doesn't seem to "catch" in the metal clip under the tail.

Argh! I want to go riding tonight! I am so close!