Wiring connection help

[Slickit]

I need a little assistance locating where certain sensors connect to and where the connections are located on the bike. Specifically looking for where the Rear O2 sensor connection is and perhaps best way of getting it in and out of there?

[d_adams]

Front O2 is behind the coolant reservoir, rear is under the lower airbox. Airbox must be removed to get to it. Kinda hard to see in this pic, but it's the connector with a little bit of blue on it right below and to the right of the one marked "front". I guess directly between the intakes would be a better description.

https://lh5.googleusercontent.com/-NVecfNX075E/Vf1Cj0TJiiI/AAAAAAAAILg/SGFAuwztGRc/w638-h851-no/gplus1056635241.jpg

[Slickit]

ok, thanks.

[Slickit]

sooooo... got it but as stated on FB earlier I cant quite seem to get the header out soo it look like I will have to do that.

Can anyone please give any tips tricks.

[rx1190kevin]

Ya don't have to take the rear header off to get the o2 sensor out. You need a o2 sensor tool, use a long extension and a universal swivel.

[d_adams]

Not enough room to use an O2 sensor socket. Open end wrench or a crow's foot will work though.

[Slickit]

pliers from the outside. Only hard part is disconnecting it.

[d_adams]

Remove the upper and lower airbox, along with the throttle bodies.