PDA

View Full Version : Fuel pump repair


d_adams
10-25-2017, 07:38 PM
Also posted this on FB. For reference on the fuel pump, this is the release tool and the repair kit you'd need. The crimp tool is listed as well on the website. It's a Delphi connector. https://www.corsa-technic.com/item.php?item_id=376 https://www.corsa-technic.com/item.php?item_id=311 This is the crimp tool. https://www.corsa-technic.com/item.php?item_id=695

If you're having issues with the fuel pump and/or errors related to it, this would be the kit to replace the connector.
Nemesis
10-29-2017, 10:00 PM
Was weird yest, didnt hear my fuel pump prime as it usually does.. Still ran but was suprised. Happened another two times but i can hear it again now...
WHat gives?
buell-fan
10-30-2017, 01:51 PM
Nemesis, it primes based on heat and loss of pressure from what I understand. Mine does it when it is fairly hot outside and the bike is hot. The other day it was in the low 50°s and didn't come on after parking her because it wasn't​ that hot and it maintained its prime.
Nemesis
10-31-2017, 08:06 PM
Interesting, thank you!

On another note the bike has taken a liking to idling at 3000 rpm lol wtf. This bike i swear to god.
buell-fan
10-31-2017, 09:17 PM
Nemesis, do a throttle position reset, and check to make sure the band clamps around the rubber gaskets on the throttle bodies​ are tight.
Nemesis
10-31-2017, 09:29 PM
Nemesis, do a throttle position reset, and check to make sure the band clamps around the rubber gaskets on the throttle bodies​ are tight.

How do you do a throttle position reset??
Cooter
11-01-2017, 12:48 AM
I noticed when I didn't have my clutch lever fully in, it would high idle at stop lights. Since I usually 2 finger the clutch there was no room for my other fingers. I actually trimmed the clutch switch to activate with the lever disengaged the clutch but not compressed against the grip.

Basically, make sure the clutch switch works....:)
buell-fan
11-01-2017, 08:06 AM
How do you do a throttle position reset??
TPS reset
Nemesis
11-01-2017, 09:40 PM
I noticed when I didn't have my clutch lever fully in, it would high idle at stop lights. Since I usually 2 finger the clutch there was no room for my other fingers. I actually trimmed the clutch switch to activate with the lever disengaged the clutch but not compressed against the grip.

Basically, make sure the clutch switch works....:)

I'll keep it mind thanks heaps brother!


TPS reset

You're a legend, thank you :)
Kid Thunder
11-02-2017, 02:23 PM
buell-fan,
Is that it to reset the TPS? sounds to simple.
EBRRider
11-02-2017, 03:28 PM
buell-fan,
Is that it to reset the TPS? sounds to simple.

That is correct, the same on the 08-10 Buells