That looks nice with the black aluminum trim panels. Did you have the stickers special made in white?
That looks nice with the black aluminum trim panels. Did you have the stickers special made in white?
Ebr 1190
My wife got me some anti-gremlin bells. That’s as close to the ground I can go lol
List of replacements to make:
- SBK tail
- Airbox cover
- Display
- Clutch reservoir
- Clutch lever delrin Tip
- Woodcraft delrin bar end slider
- Woodcraft left hand guard
- Left handgrip
- Front plastics (was going to put a full set of RX plastics on)
- Left side engine slider delrin
Engine still runs. Forks seem to be perfect, but I'll be removing the front end to get it checked just in case.
I'm also going to be adding a slipper clutch and a longer chain. Those two additions would have stopped this crash.
As for me, I've got a left tibial plateau fracture that's displaced 2mm. I'm non-weightbearing on the left leg for 3 months, then PT, and back to sport in 4-6 months total. Right ankle is sprained as well, which makes crutching pretty tough. But I'll be back for sure.
2017 EBR 1190SX
2009 Buell XB12scg
Today I put on a 44 tooth sprocket, Dean Adams oval exhaust, new ECM with the tune for the exhaust, put in an Oberon clutch slave cylinder, and changed the oil. Too tired to ride it now other than up and down the street. I should have gotten one of Dean's T-shirts to go with it. Damn it's loud!! :D
Dang man, sorry to hear that. Hope you heal up quick!
I have a new hot bodies SBK tail if you need it and maybe even a t-rex slider for that side? I'll be home in a week to check, but you don't seem to be in a hurry lol.
Glad you're OK.
FYI, check those wide rear sliders with a flat board. I was just on the edge of the tire (should have been more off the bike:() and the rear slider hit the ground (!!) taking the weight off the rear and lowsided me, came off the bike about 90mph and it high sided itself, luckily without me on it.
See how the slider hits before the peg does!!
I installed a K&P Engineering S27 reusable metal mesh filter.