My clutch is slipping

[buell-fan]

I have read that you can add a shim washer to the springs to add compression weight to them. I'd go with a fairly thick, hard anodized aluminium washer over a steel washer to keep down the rotating mass, and to build a decent amount of spring tension.

[EBRRider]

I have read that you can add a shim washer to the springs to add compression weight to them. I'd go with a fairly thick, hard anodized aluminium washer over a steel washer to keep down the rotating mass, and to build a decent amount of spring tension.

I was going to do just that, I have done that on a few of my dirt bikes, Then I thought my EBR deserves better that that,. With a ad like this I wanted to be like the big boys.

My clutch was worn below min spec, had to be replaced with stronger springs and carbon clutch, hope to last longer than the first one at 3K. Too much power,thx D Adams tune & APH pipe.

https://sphdonline.com/collections/ebr-racing-parts/products/cg1007-10az-ebr-1125r-1125cr-clutch-race-spring-kit-l18e

https://www.ebay.com/itm/EBR-Buell-E...IAAOSwglVaANT7